Click image to view full size image
USB SPI Laser Marking Card/board for the G4.0 laser machine
Quick Detail:
SPI laser marking card can be used to control the SPI G4.0 laser machine to marking,engraving,cutting on
surface of material.Software EZCAD Support SPI laser type.
Description:
- 68-pins SCSI 3 socket is used on the board to connect SPI G3 laser module directly .
- Support SPI laser type.
- 8 routes general output signal .(TTL compatible).out 4/5/6/7 can be changed to open-drain mode by
- jumper to drive small power relay directly .
- 13 routes of input(TTL compliant) .In0, In4-In13, XORG0(IN14), YORG0(IN15) .
- Compatible with USB2.0 specifications.
- Mark-on-fly: encoder can be connected to the board to measure the fly speed .
- Power supply:+-5V/3A
- Dimensions: 167mm*125.5mm*23
- USB2.0 compatible
- Only support SPI laser machine
Applicable scope:
- Laser Marking
- Laser Engraving
- Drilling circuit board with holes
- Laser marking on metal
- Wave Optional:0-39
Function:
- Fly marking
- Ruler mark
- 4 kinds of Hatch
- Two axis control
- Multi-head
- Vision mark
Specifications:
| FEATURE |
| Output digital signals for digital scan head. |
| Use 68-pins SCSI 3 socket,connect SPI G4 laser module via 68-pin cable directly. |
| Extend axes output:Two Direction/pulse signals,used to control stepping motor or servomotor |
| Mark-on-fly function with an encoder connected |
| 25 routes general digital signals(TTL compatible), 4 of the IO ports can be OC IO, can connect1 with relay. |
| 13 routes of input(TTL compliant) .In0, In4-In13, XORG0(IN14), YORG0(IN15) . |
| 8 routes of output(TTL compliant) .Out0-7 output from CON5 ,and out4-7 could be OC. |
| Original start signal:Used when marking contents are the same and high speed is required Compatible with USB2.0 .. |
| CARD PARAMETER |
| Power supply parameters: DC5V/3A |
| Connector: USB connector/DB connector |
| Signal: 8 routes general digital signal.(TTL compatible) |
